12/10/2023 0 Comments S430 ryobi![]() On the spool with the eyelets in the string head housing.Ĭut one piece of trimmer line 10 ft. Rotate the spool clockwise as necessary to align the arrows Stop the engine and disconnect the spark plug wire. ![]() Turn the spool retainer counterclockwise for SS26. Turn the spool retainer clockwise for CS26. Push downĪnd hold the spool and housing together while complet. With the eyelets in the string head housing. NOTE: Make sure the arrows on the spool are aligned Any contact with the housing or string trimmer cutting head can result in burns and/or other serious personal injury.Insert the new spool into the string head. If grass becomes wrapped around the string head, STOP THE ENGINE, dis- connect the spark plug wire, and remove the grass.Īlways hold the string trimmer away from the body keep- ing clearance between the body and the product. This will prevent grass from wrapping around the shaft housing and string head which could cause damage from overheating. Trimmer should be held at a comfortable position with the rear handle about hip height. Keep a firm grip with both hands while in operation. Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level. The use of the unit on the operator’s left side will expose the user to hot surfaces and can result in possible burn injury. Extended contact with the engine housing may result in burns or other injuries.Īlways position the unit on the operator’s right side. Only hold the trimmer as shown in Figure 9 with all body parts clear of engine housing. Do not rest or place your arm, hand, or any body part against the engine housing during trimmer operation. Overfilling the crankcase may cause excessive smoke, oil loss, and engine damage.Įngine housing may become hot during trimmer opera- tion. To the upper portion of the hatched area on the dipstick.ĭo not overfill. If level is low, add engine lubricant until the fluid level rises Level should fall within the hatched area on the dipstick. Remove dipstick again and check lubricant level. Wipe dipstick clean and re-seat in hole do not rethread. Reinstall the oil cap/dipstick and secure. Using funnel provided, add entire bottle of engine lubricant Remove the cap and seal from lubricant bottle pro. NOTE: Non-detergent or 2-stroke engine lubricants will damage the engine and should not be used. Always use a 4-stroke engine lubricant that meets or exceeds the requirements for API service classification SJ. For best operating performance, continuing to use 20W50 engine lubricant is recommended, however, SAE 30, 10W30, or 10W40 are all acceptable lubricants to use in this product. This unit is shipped with a 20W50 engine lubricant to assist in the break-in period. Engine lubricant has a major influence on engine perfor- mance and service life. Gasoline containing up to 10% ethanol by volume (commonly referred to as E10) or 15% ethanol by volume (commonly referred to as E15) are acceptable.Īttempting to start the engine before it has been properly filled with lubricant will result in equipment failure. NOTE: Fuel system damage or performance problems re- sulting from the use of an oxygenated fuel containing more than the percentages of oxygenates stated belowĬovered under warranty. ![]() Failure to safely handle fuel could result in serious per- sonal injury.ĭO NOT USE E85 FUEL. Do not smoke and stay away from open flames and sparks. from refueling site before starting engine. Never add fuel to a machine with a running or hot engine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |